大家在查：邹 separate fund 4个百分点付家会高诵 jittery 不孝使尽而是其 neuter

固溶

n.quench annealing
网络solid solution; Solution; solid solubility

固溶

英-汉网络释义

固溶

solid solution

航海及海运专业词汇英语翻译(S) ... solid shaft 实心轴 solid solution 固溶 solid spar 实心杆 ...

Solution

施工图中英文对照词汇表 - 豆丁网 ... 回火的： TEMPER 23 固溶： SOLUTION 24 可拆的： REMOVABLE 25 ...

solid solubility

机械英语词汇 ... 烧结： agglomeration 固溶： solid solubility 化合： combination ...

Sold dilute

生产装备 - 徐州一正钢管贸易有限公司 ... 超声波探伤 Ultrasonic inspection 固溶 Sold dilute 穿孔 Perforation ...

aging treatment

固溶+时效处理,ag... ... ) solid solution 固溶 ) aging treatment 固溶+时效处理 ) solution and aging treatment 固溶时效处理 ...

HR S

...货或20天期货。交货状态：热轧棒(HR)冷轴棒(CD)研磨棒(CG)热轧固溶(HR S)，常用于做耐海水各种设备、一般耐酸设备、 …

solid-solution alloying

...grain size reduction)、合金固溶(solid-solution alloying)和加工硬化(strain hardening)等方法;对多相合金而言,强化的方法除...

例句：

The CTE value of composites after solution and ageing treatment decrease obviously compared with that of annealing treatment.

复合材料固溶时效后的热膨胀系数与退火态相比明显降低。

Fibrous processing marks remain in the heat-affected zone (HAZ) with part of precipitated solid phase solved into the base metal.

热影响区内，仍可见纤维状加工痕迹，部分析出相固溶到基体中；

The precipitation is very symmetrical and the size of it diminishes with the increase of solution temperature .

当固溶温度较高时，可观察到析出相非常均匀且尺寸较小。

As can be seen from the phase chart analysis , the solid solution degree in austenite falls sharply with the descending temperature .

通过相图分析可知，奥氏体中的硫的固溶度随着温度急剧降低。

In this dissertation, semiconductor sulfide pigments were prepared by Ar atmosphere solid phase reaction through the orthogonal test .

本课题首先采用气氛固相反应法制备出了硫化物固溶体粉末颜料，并用正交实验法对工艺参数进行优化设计。

Adding elements of Zr and Cr can increase the tensile strength , and electric conduction can be improved by solution treatment .

同时，铬和锆的存在可提高合金的抗拉强度；采用固溶处理使合金具有高导电性能。

The amount of intragranular precipitates in the age treated alloy were more than that of the solution treated alloy .

时效态合金在焊核区晶内析出的第二相明显要多于固溶态。

The carbon is absorbed into the metal to form a solid solution with iron and converts the outer surface into high-carbon steel .

碳被吸收进金属与铁形成固溶体使外表面转变成高碳钢。

The cold work hardening is affected by both the recovery and recrystallization after cold work and by the solid solution temperature .

合金冷作硬化效果与合金的回复和再结晶程度及固溶处理温度有关。

The tensile strength of alloy was affected by solid solution extent and grain size of the solute atoms .

溶质原子的固溶度及晶粒尺寸共同作用于后续的时效处理过程，影响强化效果。

The results show that the required high hardness can't be achieved after forging and solution -aging treatment.

结果发现，通过锻造和固溶时效均不能有效地达到所要求的高硬度。

Compared with the samples prepared by normal aging treatment , the test samples prepared by overaging treatment have better wear resistance .

采用固溶过时效处理之后，耐磨性优于正常固溶时效处理的试样。

The corrosion resistance was enhanced by heat treatment , specially the solution heat treatment .

热处理后耐蚀性得到改善，总的说来为固溶处理的效果最优。

The effect of inverted two -stage aging on microstructure and properties of a Ni base superalloy has been studied .

研究了固溶 +两段时效热处理工艺对镍基高温合金组织及性能的影响。

The results show that the microstructure of brazing filler metal is mostly solid solution phase.

结果表明，钎料区主要是固溶体组织；

固溶

固溶