大家在查： •林肯 coroflot 买方负担萨佛瑞阿克雷山洋葛德文 shipboard 盲肠炎 ·林肯 luwak

钎焊

n.soldering hammer; braze welding
网络brazing; Soldering; Soldering and Brazing

钎焊

英-汉网络释义

钎焊

n.

1.soldering hammer

2.braze welding

3.sweat

1

The microstructure of the brazed joint was analyzed by means of a scanning electron microscope and an energy spectrum analyzer .

用扫描电镜和能谱分析仪对钎焊接头的显微组织进行了分析。

6

Brazing is the main processing methods of heat transfer, and also is a determining factor of affecting the heat transfer effect .

钎焊是换热器的主要加工方法，也是影响换热效果的决定因素之一。

8

10

WELDED AND BRAZED ASSEMBLIES FOR AEROSPACE CONSTRUCTIONS. FRICTION WELDING MACHINES. QUALIFICATION SPECIFICATIONS.

航天工业用焊接和钎焊组件 .摩擦焊接机 .合格规范

12

Welded and brazed assemblies for aerospace constructions . Electron beam welding machine. Qualification specifications.

航天结构用焊接和钎焊组装件 .电子束焊接机 .鉴定规程

13

Also can be used for brazing steel and stainless steel, hard alloy of flux .

也可作钎焊钢及不绣钢、硬质合金的助熔剂。

14

15

It is shown by experiments that copper , chosen as the material of the plating layer , can effectively improve the abradability of ceramics.

试验表明，选用铜作为镀层材料可有效地改善陶瓷的钎焊性能；

16

The system set the design and management of brazing process as a whole .

该系统集钎焊工艺设计和工艺管理为一体。

18

the lower layer coil winding end head is welded with the copper bar of the argon-arc welding through the soldering .

通过钎焊把下层线圈绕组端头与换向器铜排焊接成一体。

19

WELDING . BRASING. SOLDERING. BRAZE-WELDING. FILLER MATERIALS. ACCEPTANCE TESTING PROCEDURES.

焊接 .钎焊 .硬钎焊 .焊条 .验收试验规程

23

Welded and brazed assemblies for aerospace constructions. Resistance spot or seam welded assemblies. Quality of welded assemblies.

航空和航天制造用焊作和钎焊件 .点焊和滚轮焊的电阻焊接件 .焊件质量

25

The moulding of the case utilizes the technology of full-vacuum braze welding for satisfying the sealing requirement .

为更好的满足密封要求，机箱采用了整体真空钎焊技术进行制造。

27

Effects of fillers and brazing parameters on mechanical properties and microstructures of brazed joints were investigated .

研究了钎料类型及钎焊工艺对钎缝接头力学性能与微观结构的影响。

28

When brazing dissimilar metals you need to take the coefficient of expansion when looking at joint clearance at temperature.

当不同金属钎焊时，必须考虑他们的焊接系数？

热词推荐

大家在看